Hard Was Oil is suitable for all types of woods, even hard exotic woods. It penetrates naturally and deeply leaving an extra matt finish.

Water repellent and prevents the wood from getting dry and brittle/

A clear translucent non colouring oil and Eco Friendly with low VOC

Sold in 2.5 litre and 10 litre. Coverage for the small tin in approximately 35m2 (2 coats is recommended)

There are 3 choices of application:

• Paint Brush – Use a natural bristle brush and work on full boards at a time (5-10m2) Leave the oil to be absorbed for a few moments before rubbing off any excess oil. Lightly Brushing out and lifting off at the end of each stroke. Leave to dry for 8 hours at a minimum temperature of 16 degrees and area must be well ventilated.
   
• Lambswool Applicator – First use a natural bristle brush to work on the edges of the room. Use Lamb’s wool applicator along the full length of the floor. To avoid lab marks maintain a whet edge by overlapping sections you previously ended by several cm/inches. Leave to dry for 8 hours at a minimum temperature of 16 degrees and area must be well ventilated.
   
• Polishing machine – Apply the oil in an even coat with a low speed floor buffing machine using a white polishing pad. Continue in sections until the whole floor has been finished. Leave to dry for 8 hours at a minimum temperature of 16 degrees and area must be well ventilated. Please note some pigments cannot be applied with a polishing machine.